The ASICForce Tools utility allows you to:
Flash ASICs running stock firmware over the local network
Mass-configure and manage ASICs running Texas Miner firmware
Perform bulk administration of your mining farm
Download the latest version of ASICForce Tools from our website.
For stable operation:
On the first launch, grant all required permissions in Windows.
It is strongly recommended to run the utility inside Google Chrome.
If you experience issues, try running the tool as Administrator.
Many antivirus programs falsely flag mining tools (including stock ASIC web interfaces) as threats. Temporarily disable your antivirus or its real-time protection during the flashing process.
Before starting, make sure of the following:
Stock Firmware Version
ASICs must run on standard firmware released before September 2025.
If the current standard firmware was released in April 2024 or later and you are unable to install our firmware, you should try performing a reset on the miner. If that does not help, you will likely need to roll back the firmware first.
Use the official stock recovery image for your CPU type (available on our website).
Flash the recovery via SD card or USB, then use ASICForce in Priority mode (not Automatic) to install the target firmware.
Web Interface Password
The ASIC web interface password must be the default: root.
If it has been changed, either reset it to default or enter your custom password in the ASICForce settings.
Network Scan & Update
Scan the appropriate IP range to discover your ASICs.
Wait until all devices appear and fully boot on stock firmware (this step is important for the tool to correctly identify and select the right firmware version).
Select the miners you want to update and click “Update”.
Amlogic
No special requirements. Amlogic control boards are generally the most compatible with ASICForce.
Xilinx
After flashing a Xilinx-based ASIC, wait 2–3 minutes for the miner to fully reboot.
Cvitek
The ASICForce utility must remain running during every reboot of the miner.
Keep the “Cvitek” checkbox enabled in the tool.
The utility will automatically patch the CPU to our custom firmware.
All other settings (pools, overclocking, etc.) will be preserved.
BB (BeagleBone)
BeagleBone-based control boards (two-layer / dual-board versions) are not currently supported by ASICForce. Flashing via this utility is not possible for these models.